| 72 01 84 (815) |
Roof Racks, 2 door E30 |
Seal may remain pushed in after roof rack removal. Push entire length of
seal in to achieve good cosmetic appearance |
March 1984 |
| 72 04 85 (1125) |
Front seat belts 9/83 and later |
Introduces relocation option of shoulder belt pivot |
December 1985 |
| 72 01 87 (1325) |
Seat /Safety belt components, non interchangeability |
Warns of interior swaps causing incompatibility of seat belt components |
January 1987 |
| 72 03 87 (1541) |
Threaded front towing eye 1988 on |
Instruction for PDI placement of eye in trunk |
January 1988 |
| 71 01 88 (1645) |
SRS repairs |
List of what must be replaced after firing of airbag. |
May 1988 |
| 72 04 88 (1665) |
SRS system component replacement |
Request for diagnostic printouts to accompany all SRS parts returns |
May 1988 |
| 72 01 89 (1789) |
SRS Unit Installation Procedure |
Describes correct procedure for airbag installation |
January 1989 |
| 72 03 89 (1835) |
Handling of SRS units |
Handling and shipping procedures for airbags |
March 1989 |
| 72 01 90 (3008) |
SRS Flash Codes |
Lists 2 flash codes omitted from repair manual. |
January 1990 |
| 72 03 90 (3047) |
Seat belt guide, 325i convertible |
New guide to prevent belt twisting when allowed to retract rapidly. In
production from 3/90 |
January 1991 |
| 72 02 91 (3338) |
SRS diagnostics |
Describes how to get fault codes with the BMW service tester. |
August 1991 |
| 72 04 91 (3388) |
Pyrotechnic safety belt tensioner for 92/93 iC |
As of 10/91 production, all are fitted with pyrotechnic tensioner |
May 1994 |
| 72 01 92 (3633) |
Testing resistance of airbag igniter circuit |
Only Fluke digital volt / ohm meters are approved for this check, use of
meters with high testing voltages could ignite airbag |
September 1992 |
| 72 02 93 (3794) |
Collision repair guidelines restraint systems |
Must replace airbag, contact ring, impact sensors, control unit and
seatbelt tensioner after deployment |
May 1994 |
| 72 04 93 (3822) |
Checking airbag systems |
Re-evaluation of 3 yearly inspection requirements. No longer necessary due
to self monitoring system |
June 1993 |
