| 34 03 83 (742) |
Replacing front brake pads. |
Dust seal can get caught between piston and pad, causing damage to the
seal. |
May 1983 |
| 34 05 83 (763) |
Floating brake caliper guide bolts, 318i. |
Do not lubricate slide bolts |
September 1983 |
| 34 03 85 (1130) |
Brake lining wear warning system. |
Describes operation of the brake lining light |
January 1986 |
| 34 02 86 (1204) |
ABS sensor wire harness routing prior to 2/86. |
Re-route harness in engine bay, install mounting clip P/N 61 13 1 371 074
for connector |
June 1986 |
| 34 03 86 (1228) |
Bleeding brakes on ABS equipped cars. |
Reinforcing the need to pump pedal 12 times while bleeder is open on ABS
systems |
May 1988 |
| 34 06 86 (1292) |
Brake pads and brake shoes. |
Asbestos warning while handling brake pads |
November 1986 |
| 34 03 87 (1407) |
Routing of wires for brake pad wear sensors. |
Ensure correct routing when changing pads, cable must go through bleed
valve dust cap, P/N 34 11 1 153 198 |
June 1987 |
| 34 01 88 (1555) |
ABS warning light. |
False light after tire changes, check all tires are same size and
preferably same brand |
January 1988 |
| 34 02 88 (1585) |
Brake disc checking. |
New tools for checking rotor condition |
February 1988 |
| 34 03 88 (1671) |
ABS indicator - defective diode, after 9/87 production. |
Relocation of diode into valve relay from hydraulic unit to lower repair
costs if diode fails |
May 1988 |
| 34 05 88 (1755) |
Brake dust shields. |
Lists dangers of using such components, recommends against them |
November 1988 |
| 34 06 88 (1784) |
Troubleshooting ABS system |
Check for and replace loose pulse rings on front wheel bearings. |
February 1989 |
| 34 01 89 (1850) |
ABS sensor lead faults / repair procedure |
Introduction of repair leads, to remove the need to replace complete
harness. P/N 61 13 9 061 687 |
May 1989 |
| 32 02 89 (1857) |
ABS warning light illumination |
Adapter harness for installation of DME 1.3 control units into 325iX
produced until end of 5/88 production |
August 1989 |
| 34 04 89 (1902) |
ABS control units E30 except 325iX |
Elimination of over voltage protection relay as of 1/89 production. ABS
control unit now contains protection diode. |
July 1989 |
| 34 05 89 (1968) |
ABS control units 325iX |
Elimination of over voltage protection relay as of 4/89 production. ABS
control unit now contains protection diode. |
January 1990 |
