|
|
Cruise control, installation on non equipped car.These instructions assume you have purchased a factory cruise control kit. If you
intend to retrieve a used unit from a used parts source,
| ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
| Remove the 4 screws securing the lower steering column cover and remove the cover. |  |
 |
| Remove screw from bottom of wiper switch, and move ground lead
aside. (white arrow) Drill out hole for screw to 5.5mm (0.216"). |
 |
|
| Mount cruise selector switch on right side of column, ensuring locating tabs are correctly seated in their respective mounting holes. (Green arrows above ) | ||
| Place ground lead over mounting hole and insert a 5 x 15mm screw. | ||
| Route harness from switch alongside wiper harness down column | ||
| Cut out marked opening in lower steering column cover and install the cover. | ||
| Remove brake light switch. | ||
| Mount clutch switch onto bracket and mount the bracket with a 6x12 bolt and lock washer. | ||
| Adjust clutch so that 4 to 5mm of button is visible with clutch pedal depressed. | ||
| Install brake light switch and adjust so that 5 to 6mm of button is visible with pedal depressed. | ||
| Open glove compartment, remove pins from retaining straps and lower glove compartment to floor | ||
| Remove cover above glove compartment, and remove latch striker plate. Clearance may be gained by removing connector for DME. Arrow shows final position of cruise control unit. |  |
|
| Mount cruise control unit holder to striker plate with self tapping screws. |  |
|
| Slide control unit into holder, run wiring harness behind center console and plug into control unit. | ||
| Mount control unit and reassemble glove compartment. | ||
| Remove instrument cluster | ||
| Insert green plastic adapter plate in the rear of the cluster, if not already fitted. |  |
|
| And connect speedometer connection from cruise wiring harness. Install cluster |  |
 |
| Plug in black connector (green arrow) on cruise harness to clutch switch (blue arrow) |  |
|
| Connect cruise harness ground wire to main ground point above pedals. |  |
|
| Locate special equipment wiring plug, to the left of the
pedals, a large white connector with multiple small connectors plugged into it. Plug in the cruise harness 2 pin connector to the upper right corner of the special equipment connector. The connector will not fit in any other position. |
 |
|
| Position cruise actuator bracket on left inner fender towards headlights and mark points for mounting holes. 325i has cruise actuator mounted to air filter housing mount. |  |
|
| Drill holes and remove inner fender splash shield. Mount cruise motor bracket with nuts and bolts to the inner fender and mount motor. | ||
| Connect cable to cruise motor and connect to throttle body. Throttle body has the mounting points already installed. Adjust cable with engine idling, cruise control off, to allow a slight amount of slack in the cable with throttle completely closed. |  |
|
| 325e: Attach cruise control cable clip to inboard stud of left strut. Route cable through the clip. |  |
|
| Route wiring harness from the operating motor , along the
existing harness, into the passenger compartment and connect to the appropriate connector
on the cruise harness. Harness should be routed through the large grommet below the brake booster. Dismount fuse box from inner fender to facilitate installation of the harness. |
 |
|
Koala Motorsport recommends www.zionsvilleautosport.com for used parts and accessories.
|
|