DANGER:
Extreme risk of serious injury if air bag deploys during removal.
These instructions should be followed without deviation
in order to prevent accidental injury.
Disconnect negative cable from battery
WAIT 30 MINUTES! To allow system capacitor to discharge.
Remove the small rectangular cover on the lower
column housing.
Disconnect the lead to the slip ring.
Located near the center of the wheel, in the rear, are two T30 Torx
screws. These screws are retained in the wheel by clips, loosen them until the air
bag comes free, screws remain in the wheel.
Lift off the air bag and disconnect the wiring to the bag.
DANGER: Place the air bag face up, outside of
the vehicle, preferably in the trunk, where no injury can occur if it deploys. While it is
highly unlikely that a disconnected air bag will deploy, the potential result of such a
deployment requires due care be taken.
Remove the two T30 Torx screws securing the main contact to the wheel.
NOTE: Each screw has an insulating washer, plus each hole in the contact has a
plastic support and a spring behind it. Horn is activated when this contact plate touches
the main metal section of the steering wheel at the top or bottom.
