Exhaust system, remove and install
| Support exhaust system |
|
| Remove nuts from header flange. |
 |
| Loosen 13mm bolts on brackets and remove rubber hangers from rear cross
member |
 |
| Remove muffler bracket and lower exhaust from car. |
Installation
| Replace gasket and nuts at manifold flange. Use copper nuts. |
| Install manifold nuts and muffler bracket, and tighten
to correct torque before installing other mounts. |
| Correctly positioned exhaust must have tailpipes in center of opening in
rear valance. |
 |
| Install rubber hanger and bracket at rear sub-frame and
position bracket so that rubber hanger has slight tension only. |
Torques
|
| Pipe to manifold |
: |
Step 1, 30 Nm (22 ft lbs.)
Step 2, 50 Nm (26 ft lbs.) |
| Muffler brackets |
: |
14 Nm ( 10 ft lbs.) |
| Hanger bracket to rear sub-frame |
: |
22 Nm (16 ft lbs.) |
|
