| Disconnect negative cable from battery. |
 |
| Loosen clamp on intake boot, remove wiring from clips on boot and remove
from air box. |
 |
| Disconnect accelerator cable and cruise cable if fitted, by squeezing
plastic tabs together and pulling retainer from bracket (blue arrow). Remove nuts
(green arrows) holding cable bracket to intake air box. Place cables, still in bracket,
aside. |
 |
| Remove nut clamping brake booster vacuum hose to intake manifold (green
arrow). |
 |
| Remove hose from fitting on bottom of air box (yellow arrow). Unscrew nut
on brace below air box (green arrow). |
 |
| Remove hose from front of intake manifold beside number 1 throttle body. |
 |
| Remove nuts attaching air box to throttle bodies, remove air box. |
 |
| Remove 10mm nut securing coolant pipe to cylinder block, and 10mm nut and
bolt securing oil dip stick to coolant pipe. |
 |
| Remove all three leads from the starter. 8,10, and 13mm nuts. |
 |
| Remove the two 17mm nut/bolt's securing starter to bell housing. |
|
| Remove single 17mm bolt at front of starter |
|
| Remove starter. |
|
